The Zenith amplifier range has been designed and engineered to work in any demanding installation or touring environment with military endurance. Oversized multi-speed fans and large heat sinks will keep the output stage cool. Many amplifiers distort with both channels loaded and driven before they hit full output power. Even some expensive “brand” name amplifiers will do this when presented with multiple drivers at low impedance (inductive load). The Zenith amplifiers are designed to handle low impedance and inductive loads and when driven to excessive levels will “soft clip”. The switchable limiter system is controlled by a high speed VCA chip that will limit both peak and RMS power to prevent clipping of the output.
Features
Stereo output @ 2Ω: 1250W x 2
Stereo output @ 4Ω: 900W x 2
Stereo output @ 8Ω: 540W x 2
Bridge output @ 4Ω: 2500W
Bridge output @ 8Ω: 1800W
Frequency response: 20Hz - 25kHz
Signal to noise ratio: 107dB
Protection: DC and thermal overload
LED indicators: Power, signal, active and clip
Input connectors: Balanced XLR
Output connectors: Neutrik speakon and binding post
Fan cooled
Ground lift
Low cut filter
Filters/crossover: High pass and low pass
Switchable stereo, parallel and bridge
Other features: Full range line out, circuit breaker protection and heavy duty welded steel chassis
Specification
Power supply: 240V
Dimensions: 89 x 484 x 496mm
Weight: 18kg